для размещения заказа - smwautoblok@smwautoblok.ru
AXN® AXN®-R AXN Automatic indexing chucks 210 - 850 mm
Automatic Automatic Divisions: 4 x 90°/8 x 45°/3 x 120°/6 x 60° or specials
indexing chuck indexing chuck
standard body with reinforced body AXN-R Automatic indexing chucks, reinforced 210 - 315 mm
Divisions: 4 x 90°/8 x 45°/3 x 120°/6 x 60° or specials
Which is the right indexing chuck Besides the work piece dimensions also parameters as the clam-
diameter for my parts?
ping force, the stroke of the clamping piston, the overhang of
The complete line of AXN indexing chucks has been designed to the component from the chuck face sufcient tool clearance and
the working cycle, are relevant
clamp and index almost all kind of multi axis parts that are
possible to nd on the market Attention: The requested AXN chucksize is not only deter
mined by the size and weight of the component, but also
The important dimensions to check in the following drawing and by the production process. Therefore the determination of
the AXN-chucksize must be done in accordance with SMW-
table are: AUTOBLOK
- G diameter > the biggest diagonal of the component
- T dimension + indexing jaw room (jaw mounted on the The experienced SMW-AUTOBLOK technicians can help
indexing shaft) > 1/2 of the height of the component you in all steps of this decision process: don’t hesitate to
contact them!
Another way to check if the part can be indexed on a specic
is aischdioeHnveie(gcdaohtinefsssattmananiescthcsrip.unpirgn.amdoc.lyp)e.esrpaetieodn
chuck, is to make a simple drawing showing the part clamped in
center by the clamping jaws and its 360° rotation around the
indexing axis inside of the internal pocket of the chuck
Dimensions
clamping jaw
210 - 460
* * $;15
