для размещения заказа - smwautoblok@smwautoblok.ru
Clamping glossary
Radial clamping Self-centering clamping of work pieces on the out- If requested the D-KOMBI can also be used just for radial clamping. In
side diameter. Depending on the necessary clamping force to drive this case no clamping ngers are mounted and the clamping force is
the parts during machining thin walled components can be easily regulated by adjusting the pressure on the clamping cylinder.
deformed.
Double piston cylinder These are cylinders with two independent
Axial clamping Clamping of work pieces on their face. This method pistons. Piston A drives the swing-clamps, piston B releases the
is used for thin walled components. The radial deformation of the diaphragm or regulates the clamping force of the diaphragm.
diameter to be machined can be eliminated. This is not self-centering Depending on the application, it may be necessary to have the
clamping so that the work piece has to be positioned concentric. pressure in the supply lines for piston surfaces A/B/C/D individually
adjustable by individual pressure regulating valves. The SMW-AUTOBLOK
Kombi clamping Chucks with centering jaws for centering the work double piston cylinder ZHVD-DFR is special designed for this application.
piece with the diaphragm and axial clamping with swing-clamps. After Different rotating unions for 1 or 2 media (as an example air sensing
the work piece is clamped with a swing-clamp, the centering jaws can and coolant) can be mounted to the standard cylinder.
be opened (double piston cylinder necessary). The D-KOMBI with quick
jaw change ideally fullls these requirements. The proven design of the
D-CHUCK is maintained completely. Additionally an axial clamping drive
is integrated.
Special shaped Ideal for PICK-UP machines:
diaphragm from special Radial access for quick change
steel for longest mechanism
lifetime
High precision, patented quick jaw 5
change system by using the proven
ABS®-coupling (licence Komet)
TIR < 0.020 mm
Optionally jaws type A, B, C
Prelocator pin
jaw type C
1UICK CHANGE Clamping tooth jaws Type C
of swing Clamping of gears in the pitchline
clamps via
bajonet Workstop
s 1UICK CHANGE
s !IR SENSING
s .OZZLE FOR COOLANTAIRBLOW SMW-AUTOBLOK 169
smwautoblok@smwautoblok.ru www.smwautoblok.ru
